Usage Instructions - Vitek Blizzard VT-1836 R Betriebsanweisung

Crevice nozzle (24)
For cleaning the radiators, chinks, corners and
sofa pillows.
Furniture upholstery cleaning brush (25)
This brush is designed to clean cloth surfaces of
the soft furniture.
Small brush (26)
This brush is designed for the dust removal of the
furniture surfaces.
Pile of the brush protects the polished surfaces
of the furniture.
Floor/carpet brush (27) (fig. 5-6)
Turn the switch on the brush to the desired posi-
tion, depending on the type of the surface to be
cleaned.

USAGE INSTRUCTIONS

Extend the power cord to the desired length and
plug it into the power supply socket before use.
Yellow mark on the power cord warns of the max-
imum cord length.
Do not extend the power cord beyond the red
mark.
Attention:
- Always make sure the vacuum cleaner has the
dust box container (10) and its filters (22, 23)
installed before turning it on.
- when using the cloth (28) or paper (29) dust
box, make sure it is properly installed.
1. Press the on/off button (15) to turn the vacuum
cleaner on.
2. While using, adjust the suction power by the
governor (14).
3. When finished using, press the on/off button
(15) and unplug the appliance.
4. Press the reeling button (11) to reel the power
cord and secure it by your hand to avoid its
whipping and damage.
Usage of the cloth or paper dust box (fig 7)
• Open the cover (6), pressing the catch (7).
• Press the dust box holder (8), install the cloth
(28) or paper dust box (29), release holder (8),
make sure the dust box frame is firmly set.
• Close the cover (6).
1836.indd 7 1836.indd 7
Removal of the paper or cloth dust box:
- open the cover (6), press the holder (8) and
remove the dust box.
- paper dust box (29) is disposable and is sub-
ject to utilization when full
- cloth dust box (28) is nonexpendable. Remove
the dust and rubbish from it by sliding the plas-
tic clamp. Then place the clamp back to its
place.
SERVICING
1. Removing the dust box container (10) and
cleaning it from dust and rubbish (fig 8).
• Turn the vacuum cleaner off and unplug it
• Press the catch (7) and open the cover (6).
• Extract the dust box container (10), taking it by
the handle (19).
• Open the lower cover of the dust box container
(21), by pressing the lock button (20).
• Remove the dust and rubbish from the dust
box container.
Note:
- it is recommended to clean the dust box con-
tainer after each use of the vacuum cleaner.
- Dust box container filling indicator (13) will
light, reminding you to clean the container and
filters.
2. Disassembling the dust box container
(fig 9).
• Turn the vacuum cleaner off and unplug it, re-
move the dust box container and clean it from
the dust and rubbish, close the lower cover.
• Remove the НЕРА-filter (23) from the dust box
container (10).
• Turn the net pre-filter counter-clockwise (22)
and remove it from the dust box container.
3. Cleaning of the filters (fig 10)
Maintain the filters clean (22, 23), for they define
the efficiency of the vacuum cleaner. Clean the
filters at the least three, four times a year, and if
heavily used – more often. Replace the filters as
needed.
• Turn the vacuum cleaner off and unplug it, re-
move the container (10) and clean it from the
dust and rubbish, remove the filters (22, 23)
from it.
7
ENGLISH
30.08.2007 12:13:29 30.08.2007 12:13:29