Velleman CAMCOLVC6 Bedienungsanleitung Seite 6

CAMCOLVC6
Switch the camera on by pressing the camera ON/OFF pusher
x
[D] for ±2s. The status LED [C] will light up blue.
Press the ON/OFF pusher [D] shortly to start recording. The blue
x
status LED [C] flashes and than switches off.
Press and hold the ON/OFF pusher [D] for ±2s to stop recording
x
and deactivate the camera. The status LED [C] flashes red and
than switches off.
To take a snap shot, activate the camera by pressing the ON/OFF
x
pusher [D] for ±2s. The status LED [C] will light up blue.
Press the snapshot pusher [F]. The status LED [C] will briefly
x
turn red and than returns to blue.
Connecting to USB port
Remove the cover of the USB port [E] and plug the jack of the
x
included USB cable into the port. Plug the other end into a suitable
powered USB port. The status LED [C] turns green.
The watch now acts as a removable storage medium. Browse it and
x
open the AVI-files with a suitable player.
Press the reset pusher [F] before disconnecting the USB port from
x
the PC.
Always place the USB cover back after using the USB port.
x
Adjusting the wristband
Refer to the illustration on page 3 of this manual.
First determine the appropriate size of the wristband. Count how
x
many links should be removed.
[1] Use a small screwdriver to push the protrusion on the link next
x
to the clasp down and away from the wristband (see arrow on
image).
[2] Pull out the pin completely.
x
[3] Slide the link over the connection plate.
x
Count the number of links to be removed and repeat the above
x
procedure [1-3].
Note: it is better to remove e.g. 2 links on either side of the clasp than
4 links on one side and none on the other.
Hook the last link back over the connection plate.
x
Re-insert the pin. Make sure it does not stick out of the wristband.
x
Small changes in wristband size can be achieved by moving the
x
clasp itself. Use a small object (e.g. an unfolded paperclip) to gently
press on the flanged spring bar. Re-insert the spring bar on one side
into the desired location, press the flange on the other side of the
bar down and move the wristband until the spring bar snaps into
6
Rev. 01
©Velleman nv