Lelit PG1 Handbuch Seite 19

PG028N
5. In normal use the steam will always be available.
pressure and volume will decrease and, in some cases the unit may require a few moments for the chamber
to be brought back to "ready" temperature.
 NOTE: DURING NORMAL OPERATION SOME STEAM MAY ESCAPE FROM THE NOZZLE WHEN NOT
BEING USED. THIS IS JUST SMALL AMOUNTS OF WATER LEFT IN THE CHAMBER TURNING TO
STEAM.
CAUTION
AFTER RELEASING FOOT PEDAL, THIS UNIT WILL CONTINUE TO STEAM FOR APPROXIMATELY 15
SECONDS. THIS IS NORMAL OPERATION
DO NOT TOUCH THE STEAM NOZZLE ASSEMBLY DURING USE OR UNTIL IT COOLS AFTER USE. IT IS
HOT. DO NOT BLOCK STEAM NOZZLE BUT, IF IT BECOMES PARTIALLY CLOGGED REMOVE WHEN
COOL AND CLEAN THOROUGHLY
TROUBLESHOOTING, in addition to what described for the ironing machine PG1:
PROBLEM
1) Does the nozzle 1) While filling the tank you may
or gun leak water have poured too much water into it.
mixed with steam?
2) There is no 1) The steam knob (where
steam coming out supplied) might be closed
of the nozzle or 2) The foot pedal is not plugged in
gun? 3) The boiler switch might be off
4) The water might be used up.
TECHNICAL DATA:
Working voltage: 220-230 V 50 Hz
2 power cords to be plugged in 2 different sockets
Nominal capacity of the tank: 9 Liters
Boiler power 2 heating elements: 2*1500W each
Service pressure: 3,5 Bar
Maximum pressure: 5,5 Bar
EXPLANATION
However, for long or extended steam outputs the
SOLUTION
1) The problem will go on until the excess water
emptied. Keep the steam button depressed until the
water in the tank is at the correct level.
1) Open the steam knob anticlockwise.
2) Plug the 4-pin receptacle into the boiler.
3) After the boiler switch comes on, wait for 10
minutes so the boiler produces steam.
4) Fill it following the instructions carefully.
English
is
Pag. 19