Lelit PG1 Handbuch Seite 18

PG028N
COMPONENTS:
1. Safety cap
2. Wand support
3. Switch for socket power supply "Steam"
4. Boiler switch
5. Low water red pilot light
6. Cable and plug
7. Regulator for steam outlet
The PG028N has the same technical features of PG1 but it does NOT HAVE A PUMP, hence it's possible to
charge water only manually
USER INSTRUCTIONS:
1. Before using the item, take it off from the packing box and make sure to remove all the packing components
and the protective bags.
2. Lay the item on a steady and flat surface nearby a wall-socket (1,5 mt maximum).
3. Connect the optional accessory's plug into the socket (9) and the accessory's steam hose into its brass "L"
connector (10) and fix it by a hose-clip band. Repeat the same operation with the second socket and the second
"L" connector, if it is necessary to connect two accessories at the same time. Put the supplied wand in the right
seat (2) and hook the steam hose and the cable.
4. Before beginning any operation, make sure that the exhaust valve (10) placed on the side is closed and the "L"
joint is screwed up with the outlet downwards.
5. Unscrew the cap (1) and fill the boiler with max. 7 liter water, being careful not to overspill, and close the cap
(1).
6. Insert the plug (6), switch on the boiler button (4) and the steam button (3).
7. Set the temperature regulation knob of the iron plate on "cotton" (marked on the knob with "
8. Keep waiting for the turning off of the boiler button light (4), it takes about 15 minutes (while ironing the light
comes on).
9. The machine is ready for use.
10. Press the steam button of the iron.
11. It is possible to regulate the steam quantity by the belonging knob (7).
12. In case the steam stops during ironing and the low water light indicator (5) comes on, it means that there
is not enough water in the tank. To start ironing again, switch off the boiler switch (3); press the steam
iron button (8) to ensure there is no more steam in the boiler, slowly open the pressure cap (1),
disconnect the plug and refill to the required level. Fill the boiler with warm water and wait for it to build
up pressure again.
13. When you first press the steam button (after having turned the boiler on and depressed the steam button
on the iron) you might notice a decrease in pressure. This is because the tank has air in it. In order to
have plenty of steam (after you have depressed the iron) wait until the pressure goes back up to the
maximum level before you begin.
CAUTION! SEE NOTES DESCRIBED AT PAGE 5 FOR MODEL PG1
MAINTENANCE: SEE NOTES DESCRIBED AT PAGE 6 FOR MODEL PG1
Additional accessories to PG028N to be purchased separately FOR BEING USED BY Jewellers and
dentists:
PG036/1: iron
PG036/5: steam gun
PG036/6: steam brush
PG036/10: Steam metal pipe and electric foot pedal
Special instructions for using the PG028N together with the kit for Jewellers or dentists PG036/10
1. Plug the power cord into a 230V socket
2. Insert the metal steam pipe and the foot pedal
3. Place the foot pedal on the floor so that it rests conveniently on a flat surface.
4. To make steam, wait until the "ready" light comes on for the first time.
approximately three to five seconds.
Pag. 18
8. Plug for irons and solenoid valve control
9. "L" connector for steam outlet
10. Water discharge tap
11. Steam pipe
12. Steam gun
13. Electric pedal
English
ooo
").
Then push the foot pedal for