Periods Of Non-Operation; What To Do If - Atag KF8178CDL Benutzerhandbuch

The absence of frost is due to the continu-
ous circulation of cold air inside the com-
partment, driven by an automatically con-
trolled fan.

Periods of non-operation

When the appliance is not in use for long
periods, take the following precautions:
• disconnect the appliance from elec-
tricity supply

WHAT TO DO IF...

Warning! Before troubleshooting,
disconnect the mains plug from the
mains socket.
Problem
The appliance does not
operate. The Pilot light
does not flash.
The Pilot light flashes.
The Alarm light flashes.
The compressor oper-
ates continually.
The temperature in the
freezer is too low.
The temperature in the
freezer is too high.
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The appliance is not working
properly.
The temperature in the freezer is
too high.
The temperature is not set cor-
rectly.
The door is not closed correctly.
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
The temperature regulator is not
set correctly.
The Fast Freeze function is
switched on.
The temperature regulator is not
set correctly.
Many products are stored at the
same time.
Products are too near to each
other.
• remove all food
• defrost (if foreseen) and clean the appli-
ance and all accessories
• leave the door/doors ajar to prevent un-
pleasant smells.
If the cabinet will be kept on, ask some-
body to check it once in a while to prevent
the food inside from spoiling in case of a
power failure.
Only a qualified electrician or compe-
tent person must do the troubleshoot-
ing that is not in this manual.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.
Contact a qualified electrician.
Refer to "Excessive Temperature
Alarm"
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
Set a higher temperature.
Refer to" Fast Freeze function".
Set a lower temperature.
Store less products at the same
time.
Store products so that there is
cold air circulation.
21
Solution