Installation And Ventilation Information; Setting Up; Connecting To The Mains; Operation And Control Elements - Atag KD8140CD Gebrauchsanweisung

appliance.
Avoid prolonged skin contact with cold surfaces or chilled/
W
frozen food. This could cause pain, numbness and frostbite.
In the case of prolonged skin contact, protective measures
should be taken, e.g. gloves should be worn.
Do not eat ice-cream, particularly ice lollies or ice-cubes, imme-
W
diately after taking them from the freezer compartment as there
is a risk of "burning" because of the very cold temperatures.
Do not consume food which has been stored for too long, as
W
it could cause food poisoning.

Installation and ventilation information

When setting up/fitting ensure that the refrigerant circuit pipes
W
are not damaged.
Avoid positioning in direct sunlight or next to an
W
oven, radiator or similar.
W Do not block the ventilation areas. Always
ensure that there is good ventilation and that
the outward flowing air is able to escape!
Standard EN 378 specifies that the room in which
W
you install your appliance must have a volume of
1 m per 8 g of R 600a refrigerant used in the appliance, so
3
as to avoid the formation of inflammable gas/air mixtures
in the room where the appliance is located in the event of a
leak in the refrigerant circuit. The quantity of refrigerant used
in your appliance is indicated on the type plate on the inside
of the appliance.
Fit the refrigerator/freezer in stable kitchen units only.
W
Please follow the enclosed installation instructions.
W
Remove all transportation safety components.
W

Connecting to the mains

Power supply (AC) and voltage
at the operating point must comply with the details on
the type plate, which is located inside the appliance on
the left, fig. A.
W Connect the appliance with a properly earthed
fused plug and socket only.
W The socket must be fused with a 10 A fuse or higher, it must
be away from the rear of the appliance and must be easily
accessible.
W Do not
- connect to stand-alone inverters ,
- operate with so-called energy-saving plugs - this can damage
the electronic system.
- connect to the supply with other equipment using an extension
cable - risk of overheating.
When removing the mains cable from the back of the appliance,
W
cable holder
remove the
16
to prevent vibration noise.

Operation and control elements

Switching the appliance on and off
W Switching on: Turn the temperature control
that the slot is pointing to setting 2.
- A green light on the display
the appliance is in normal mode.
- The red visual warning light will be on until the freezer has
reached a sufficiently low tempera-ture, then it goes out. See
"Audible warning signal, red visual warning light" for more
information.
W Switching off:
Set the temperature control to
- The temperature display and all buttons will go out.

Setting the temperature,

W Turn the temperature control
- until the display next to the temperature range wanted
3
(-18 °C) is illuminated, or
- turn the slot of the temperature control to setting 3,
fig. A1. The setting of the slot significy.
Setting 1 = lowest cooling setting
lowest cooling setting
Setting "max." = lowest temperature
highest cooling setting
Recommended temperature setting: -18 °C
W
setting 3.
Temperature setting display ,
- When the temperature display is illuminated, this indicates that
the appliance is running.
- The five blocks in the display each relate to a different tem-
perature range. They indicate the freezer temperature setting
you have selected.
- Within the temperature / setting range, e.g. when the display
reads -15 °C to -18 °C, or between two settings , the temperature
can be set slightly colder. If required, slowly turn the temperature
control further - the light displaying the temperature range,
1
flashes
e.g. -18 °C, for a short time. This confirms the higher
setting within the small temperature range.
Audible warning signal , red visual warning light
A1
fig.
The audible warning signal and the red visual warning light are
designed to help you to protect your frozen food and to save
energy.
W The audible warning device is switched off
the audible warning button
- It switches off automatically as soon as the temperature is low
enough.
- It always sounds if the freezer temperature is not low enough
(dependent on the temperature setting).
,
A1
fig.
with a coin so
1
will light up and indicate that
3
"0"
.
A1
fig.
with a coin:
1
,
or control
A1
fig. /
3
by pressing
or
4
,