Herunterladen Inhalt Inhalt Diese Seite drucken

Use - Silvercrest SVM 3.7 A1 Bedienungsanleitung Und Sicherheitshinweise

Vakuum-massagegerät
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Use

WARNING! RISK OF INJURY!
To avoid bruises:
Before switching on, make sure that appliance is set to the lowest intensity
(dial 1 to "L" = LOW, low suction) . Always start with the lowest intensity
and increase this gradually if required (dial 1 direction "H" = HIGH,
strong suction) .
Be especially careful when treating sensitive and non-firm regions of the
body, such as the face!
Do not treat the same region of the body for too long or with too much
force . Do not treat the same area several times in succession .
Every body reacts differently . If you find an application unpleasant, reduce
the intensity, try another region of body or stop the treatment completely .
NOTE
Use the appliance every two days until you are satisfied with the result .
Use the appliance only on regions of the body with sufficient fat tissue .
Application on fat-free regions does not achieve any effect and will usually
be experienced as unpleasant .
Rub the areas to be treated with a small amount of a cosmetic product
containing oil (e .g . body oil) so that the appliance slides over the skin more
smoothly .
You can stop the vacuum at any time by turning the dial 1 .
Fit the appropriate attachment 8 9 . See the Attachments section .
Use the programme switch 3 to select the appropriate programme .
See the Programmes section .
Make sure the dial 1 is set to "L" (= LOW, low suction) .
Hold the opening of the attachment 8 9 on the area to be treated and
move the On/off switch 2 to "ON" . The control lamp 4 lights up green in
battery mode, or orange if the appliance is charging at the same time .
The appliance immediately starts to suck in air and a vacuum is formed in the
attachment 8 9 .
Move the appliance over your skin following the movements described in the
Typical applications section .
Change to an adjacent area in the suction pause . Make sure the areas do
not overlap . You should not treat the same area several times in succession!
40 
GB │ MT
SVM 3.7 A1

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis