Shelf Holders; Electrical Connection - AEG SANTO K 8 12 03-6i Benutzerhandbuch

Shelf holders

Your appliance is equipped with
shelf retainers that make it possible
to secure the shelves during trans-
portation.
To remove them proceed as follows:
Move the shelf holders in the direc-
tion of the arrow, raise the shelf
from the rear and push it forward
until it is freed and remove the
retainers.

Electrical connection

A correctly installed, earthed socket is required for the electrical sup-
ply. The supply must have a fuse rating of at least 10 Amps. If the
socket is not accessible once the appliance is built in, the electrical
installation must include suitable means of isolating the appliance
from the mains (e.g. a fused spur).
Before initial start-up, refer to the appliance rating plate to ascertain
if supply voltage and current values correspond with those of the
mains at the installation location.
e.g.: AC 230 ... 240 V 50 Hz or
(i.e. 230 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
26
230 ... 240 V ~50 Hz
Installation
A
B
C