Maintenance - Ayce NC600JS Gebrauchsanweisung

4. If the saw jumps or bounces as you cut, change to a blade with finer teeth.
5. If the blade begins to clog when cutting soft metal, change to a blade with
coarser teeth.
6. For easier cutting, lubricate the blade with a stick of cutting wax (if available)
or cutting oil when cutting steel.
7. Thin metal should be sandwiched between two pieces of wood or tightly
clamped on a single piece of wood (wood on top of the metal). Draw the cut
lines or design on the top piece of wood.
8. When cutting aluminum extrusion or angle iron, clamp the work in a bench
vice and saw close to the vice jaws.
9. When sawing tubing with a diameter larger than the blade is deep, cut through
the wall of the tubing and then insert the blade into the cut, rotating the tube
as you saw.
180730_ayce_NC600JS_IM

MAINTENANCE

CAUTION!
Always disconnect the device before performing any adjustment or maintenance
operation. If the supply cord is damaged, it must be replaced by the manufacturer or
its service agent in order to avoid a hazard.
Disconnect from the power supply immediately if the supply cord is damaged.
Take care not to expose this tool to the rain.
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, carbon dust, etc.
STORING
Store the machine, operating instructions and where necessary the accessories in the
original packaging. In this way you will always have all the information and parts ready
to hand. Pack the device well or use the original packaging in order to avoid transit
damage. Always keep the machine in dry place.
DISPOSAL
Do not dispose of power tools into household waste! According the
European Guideline 2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national right, power tools that
are no longer usable must be collected separately and disposed of in an
environmentally correct manner.
92 93 |
GB
180730_ayce_NC600JS_IM