Installation; Package Contents - Avigilon DOME-OD-BASE Installationsanleitung

Installation

Package Contents

Ensure the package contains the following:
• Avigilon High Definition IP Dome Camera Indoor/Outdoor
Mounting Base
• 3 screws for mounting dome
• 4 screws, rubber sealing washers, and anchors for solid
walls
• 3/4" NPT Closure Plug
• Teflon sealing tape
• Drill template
Mounting the Indoor/Outdoor Mounting Base
Caution — The dome camera must be mounted as
instructed below or problems with moisture may arise and
will not be covered by the dome camera warranty.
Perform the following steps to mount the indoor/outdoor mounting
base to the ceiling or wall:
1. Determine where the cables will enter the camera. The
mounting base has two cable entry holes: one on the side
and one on the bottom of the mounting base.
a.
b.
2. Attach a conduit connector to the cable entry hole. Install
the conduit and its fitting as instructed by the
manufacturer.
Use the supplied 3/4" NPT closure plug to fill the
unused cable entry hole.
When installing outdoors, wrap the thread of the
plug with the supplied Teflon sealing tape to create
a water tight seal.
1