SMART Room System Konfigurationshandbuch Seite 13

SOFTWARE CONFIGURATION GUIDE
SMART ROOM SYSTEM FOR MICROSOFT LYNC
2. Press the Input Select button
the input source is HDMI3/PC .
3. Flick the power switch on the bottom of the left interactive flat
panel.
4. Press the Input Select button
front control panel until the input source is HDMI3/PC .
The Lync appliance begins the first-run installation process. During this process, the Lync
appliance restarts several times.
NOTE
This process takes time to complete. During this process, displays might not change
content or might appear blank for several minutes.
5. Press MENU on the left interactive flat panel's remote control.
6. Press the down arrow until you select the OPTION menu, and then press OK.
7. Press the down arrow until you select Lync® Room Reset , and then press OK.
8. Press the left arrow to select Reset , and then press OK.
11 smarttech.com/kb/170608
on the right interactive flat panel's front control panel until
on the left interactive flat panel's