Werbung
4 OPERATION
Access the main menu
With the monitor in stand-by and no other videointercom
turned ON within the installation, access the menu by touching
any active point of the sensor wheel.
From the main menu the user can access all programming,
set-up, adjustments and activation sub-menu.
Access the "Favourite buttons" menu (direct
activation of functions)
Press any one of the six buttons on the side of the screen, will
appear the functions associated with each individual key (if
programmed in "Favourite buttons" - see section 3.4 "Set-up
menu diagram" on page 34 ).
Empty
Empty
Silent
The keys can activate the programmed function only when the
monitor is turned ON.
How to display next/previous functions of a page
Sylvia
Christina
Office
John
Concierge
Back
If on middle bottom screen are displayed 2 or more boxes
it means that the functions are present in several pages. Use
the keys
or rotate the wheel sensor to move from one
page to another.
Empty
Empty
Gate
Neal
Grandparents
OK
- 35 -
Videointercom
Following an incoming call from the outside or by touching the
key "
", on the screen is displayed an image for about 30
seconds. By touching the key "
to communicate to external stations for about 90 seconds.
To shut down the videointercom touch the key "
the timer to expire.
The electrical lock can be operated by touching the key
Touching the keys, without receiving a call, the user operates
the electrical lock of the last calling entrance.
With the videointercom image displayed, the user can adjust
the audio/video parameters or select other entrances (if any),
by touching the side keys.
Video settings (contrast, brightness and colour)
Disabling/enabling videointercom microphone
Ringtone disabling (see section "Ringtone disabling)
Adjusting the audio and ringtone volume (attention! New
the settings are permanently stored in the memory)
List of additional services available (video cameras,
actuators, etc.)
Operating the automatic gate or supplementary video
camera
Ringtone disabling
The ringtone can be disabled instantly upon receiving an
incoming call by touching the key
ringtone will be enabled automatically.
To permanently disable the ringtone you must access the
"Favourite buttons" and touch the key
flash to indicate that the ringtone has been disabled and will
keep ON flashing until the ringtone will be reactivated again by
the same procedure.
" once again, it is possible
" or wait for
;
. At the next call, the
; the symbol will
Mi 2478
Werbung
