The Heat Setting; Automatic Heat Up; Power Function - AEG Electrolux KFA58SIM Benutzerinformation

• You do not deactivate a cooking zone or change the heat setting. After some time,
comes on and the appliance deactivates. See the table.
The times of Automatic Switch Off

The heat setting

The cooking
zone deactivates
after
The heat setting
Touch to increase the heat setting. Touch
shows the heat setting. Touch

Automatic Heat Up

You can get a necessary heat setting in a shorter
time if you activate the Automatic Heat Up func-
tion. This function sets the highest heat setting
for some time (see the illustration), and then de-
creases to the necessary heat setting.
To start the Automatic Heat Up function for a
cooking zone:
1. Touch
display.
2. Immediately touch
on in the display.
3. Immediately touch
the necessary heat setting comes on. After 3
seconds
To stop the function touch

Power function

The Power function makes more power available to the induction cooking zones. The Power
function is activated for 10 minutes at most. After, that the induction cooking zone auto-
matically sets back to highest heat setting. To activate, touch
vate, touch
Power management
The power management divides the power be-
tween two cooking zones in a pair (see the illus-
tration). The power function increases the power
to the maximum level for one cooking zone in the
pair. Automatically decreases the power in the
second cooking zone to a lower level. The display
for the reduced zone change between two levels.
-
6 hours
and
. The symbol comes on in the
. The symbol
again and again until
comes on in the display.
.
or .
Operating instructions
-
5 hours 4 hours
to decrease the heat setting. The display
at the same time to deactivate the cooking zone.
11
10
9
8
7
6
5
4
3
2
comes
1
0
1
-
1.5 hours
2 3 4 5 6 7
, comes on. To deacti-
47
8 9