Dmx Protocol - EuroLite LED TMH-X4 Bedienungsanleitung

Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
data received at the DMX-input, the DMX indicator next to the display will light up. If there is no data
received, the DMX indicator will not light up.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
aaa
aaa
aaa
2 3
1
aaa
aaa aaa
aaa aaa
aaa aaa
aaa aaa aaa
aaa aaa
aaa aaa aaa
aaa aaa aaa
aaa aaa aaa
aaa aaa
aaa aaa
aaa aaa
aaa aaa

DMX protocol

16 channel mode
Channel Value
Horizontal movement (PAN)
Push slider up in order to move the head horizontally (PAN). Gradual head
1
0 255 adjustment from one end of the slider to the other (0-255, 128-center). The head can
be stopped at any position you wish.
PAN-movement with 16-bit resolution
2
0 255 Fine indexing
Vertical movement (TILT)
Push slider up in order to move the head vertically (TILT). Gradual head adjustment
3
0 255 from one end of the slider to the other (0-255, 128-center). The head can be stopped
at any position you wish.
TILT-movement with 16-bit resolution
4
0 255 Fine indexing
PAN/TILT speed
0 0
No function
5
1 212 Decreasing speed
213 255 No function
Dimmer intensity
6
0 255 Gradual adjustment of the dimmer intensity from 0 to 100 %
Strobe
0 3 No function
7
4 95 Strobe effect with increasing speed
96 176 Random strobe effect
177 255 Pulse-effect in sequences (Thunder strobe)
Red
8
0 255 Red 0 - 100 % increasing
Green
9
0 255 Green 0 - 100 % increasing
The LEDs of the device are arranged in two different segments (see graphic) and
can be individually controlled with the following DMX-protocol.
Feature
25/32 00124465.DOCX, Version 1.0