Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
The device can be fastened via its base to a truss or similar rigging structure in any orientation without
altering its operation characteristics. The device must never be fixed swinging freely in the room.
1
The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2
Block access below the work area and work from a stable platform when installing the device.
3
Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section for a list of suitable rigging hardware and follow the
instructions mentioned at the bottom of the base. Screw one clamp each clamp via a M10 screw and
self-locking nut onto the Omega-holder. Insert the two quick-lock fasteners of the Omega-holders into the
respective holes on the bottom of the device. Tighten the quick-lock fasteners fully clockwise.
4
Secure the device with a safety bond or other secondary attachment. This secondary safety attachment
must be sufficiently dimensioned in accordance with the latest industrial safety regulations and
constructed in a way that no part of the installation can fall down if the main attachment fails. Install the
safety bond by inserting the quick link in the eyelet on the bottom of the base. Pull the safety bond over
the trussing system etc. Insert the end in the quick link and tighten the fixation screw. Fasten the safety
bond in such a way that, in the event of a fall, the maximum drop distance of the device will not exceed
20 cm.
5
After installation, the device requires inspections periodically to prevent the possibility of rot, deformation
and looseness.
2
1
4
22/32
(1) Omega-holders
(2) Clamp
(3) Safety-rope
(4) Quick-lock
fastener
3
00124465.DOCX, Version 1.0
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
