Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Other Abnormal Situations:
Heater Overheat
No Heating
No Fluid
• If fluid is run out, full the tank with fluid and press START/STOP to reset.
Very Important:
Please do not pull out the power suddenly when the machine is
in normal faze condition.
Maintenance
Before doing maintenance, please make sure that the power is cut,
the power cord is unplugged, and the machine itself has cooled down.
The maintenance must be done by qualified person.
1. The fluid is not allowed to get dirty. Be sure to always clean or
replace the caps on the tank (Replace the caps on the tank directly.
This kit includes quick connector, cap, pipe and filter) and tight the
cover of the faze machine tank immediately after filling.
©Copyright LOTRONIC 2018
Flashing and showing this status, means
heater is too hot or thermo sensor is cut;
Flashing and showing this status, means
unable heating;
Flashing and showing this status, means fluid
runs out or pumping no fluid; at this moment,
speed of the fan will reduce to minimum, and
pump will stop working.
16
Werbung
Inhaltsverzeichnis
