Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fan Power: 5
5.
____ IDLE ____
XXXXXXXXXX
6.
____ IDLE ____
XXXXXXXXXX
7.
____ IDLE ____
• When executing continuous fogging, interval value must be zero, if the
interval value change to 5-250 will automatically be converted to timing
fogging.
Timing Fogging Operation
Panel control, DMX signal is not connected.
XXXXXXXXXX
1.
Vol=xxx Fan=xxx
2. Press MENU to enter to Interval;
Interval: 6s
3.
____ IDLE ____
4. Press again MENU to switch to adjust the value of duration, please note
timing fogging still stops at the same moment;
Press "Up" or "Down" to adjust fan speed (5
-100%), press MENU to switch Volume and Fan
Power;
Press again START/STOP to stop Continuous
fogging. Please note the machine design of
machine stops working after a delay of 30
seconds, automatically clear the tubing of the
remaining liquid, at this point, IDLE will blink;
After the Self-cleaning process is complete, IDLE
will stop blinking.
Under this status, press MENU to get into timing
setting, please note timing fogging stops at the
same moment;
The first line is the setting state, usually shows
the last setting in the last operation, such as
DMX, Address, or Volume, or Fan, Power, and
so on, the following will be replaced by XXXXX.
The second line shows the real-time working
state.
Press "Up" or "Down" to adjust the value of
interval (0s or 5s - 250s);
11
©Copyright LOTRONIC 2018
Werbung
Inhaltsverzeichnis
