Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a
solution is found. Once the unit operates properly, do not carry out
following steps. If the problem persists, refer servicing to a qualified
technician.
Power Connected but No Faze is Emitted:
1. Check the power supply. Plug the unit into grounded electric power
supply socket with proper voltage.
2. Disconnect the machine from electric power supply. Replace fuse
with one of the same type.
3. Keep sufficient fluid in tank.
4. Check if pump is working (with fluid flow or not).
5. Check if the heater is heating (touch the panel to see if it is
warming).
6. Check your controller if in correct connection.
7. Check your DMX address setting.
Power Connected, Fog Blasts not Smooth:
Moving the machine during operation could probably get air entered
into the liquid pipe and affect smoothness of fog blasts. If this
happened, press START/STOP button to fog for a moment. Until the
air is dispersed from the pipe, the machine will recover its normal
fogging.
Should there be any low fog emitted, running noisily or hindered
fogging, pull out the plug immediately. Check if string enough fluid,
if the pipe connected to the tank is clean, if there's air inside the pipe,
if the liquid flows, if not, plug-in again; still persists abnormal running,
and If causation is unclear, stop running to avoid any damage, shut
down to cool it, and bring unit to your local agent or appointed
service place for inspection, prohibit any dismantlement by yourself.
15
©Copyright LOTRONIC 2018
Werbung
Inhaltsverzeichnis
