Ariete Cafe Retro 1385 Bedienungsanleitung Seite 10

DESCRIPTION OF THE CONTROLS AND COMPONENTS
A. On/off switch
Lifted position (
Lowered position: coffee maker off
B. On warning light
C. Coffee brewer/steam switch
Central position: standby
Position ( ): steam distribution
Position ( ): coffee distribution
D. Heating unit warning light
E. Heating unit thermostat (ºC and ºF)
F. Steam lever
G. Water collector tray
H. MAXI CAPPUCCINO attachment and wand for water and steam supply
I. Removable water tank
J. Cord + plug
K. Removable coffee cup storage
L. Filter ring
M. Thermocream® disc
N. Thermocream® filter
O. Measure
P. Coffee presser
Q. Pod ring (only for model 1385/1)
R. Cord housing
Check that the mains voltage is the same as the one indicated on the appliance plate containing
technical information. Place the coffee maker on a flat surface. Fill the tank with cold water, 0.7 liters
(MAX), then reinsert it carefully in its housing. Remove the cord from its housing (R) and unwind it
completely. Insert the plug in a socket which must be equipped with a ground connection.
Start the coffee maker by lifting switch (A) into the (
indicating that the coffee maker is on and the heating unit will begin heating. The first time you use it,
put switch (C) in the coffee (
water should drain from the heating unit hydraulic circuit. Once finished put switch (C) in the
center position and wait until warning light (D) goes off. At this point the coffee maker is ready to
brew coffee.
) coffee maker on
PRELIMINARY PHASES FOR USE
) position until water comes out of the filter ring. At least a cup of
) position. The warning light (B) will go on,
8
GB