Keysight U1271A Schnellstart Handbuch Seite 14

Continuity tests
Set up your multimeter as shown in the figure
below to perform continuity tests. Press
switch to the continuity test function (
on the display).
You can set the beeper to sound and the
backlight to flash as a continuity indication
whether the circuit-under-test is less than (short)
or more than or equal to (open) the threshold
resistance.
Press
(
NC (normal close) contacts.
The continuity function detects intermittent shorts
NOTE
and opens lasting as short as 1 ms. A brief short or
open causes the multimeter to emit a short beep
and flash.
14
to switch between short (
Dual
E xit
) states for checking NO (normal open) and
Keysight U1271A/U1272A Quick Start Guide
is shown
) and open
OFF
( open)
ON
( closed)
to