Power Switch - Sony CSP-5000E Bedienungsanleitung

1 VIDEO IN terminals (1 to 128) (BNC type)
Inputs video signals.
2 VIDEO OUT terminals (1 to 32) (BNC type)
Outputs video signals.
3 ALARM IN connectors (pin 1 to 256)
Connects to a maximum of 256 alarm sensors.
Opening the pin or short-circuiting the pin to the
ground will activate the alarm. The condition (opening
or short-circuiting) can be set differently for each pin.
4 ALARM RESET connector*
5 ALARM OUT connector (pin 1 to 32)
Outputs a signal when an alarm is activated. This
connector can be connected to an external device (such
as a time-lapse VTR) to activate it by an alarm signal.
6 KBD I/F (keyboard interface) connectors (1 to 7)
Connects to the KBD I/F connector of the CSPK-
5000E System Keyboard (not supplied).
7 RCV I/F (receiver interface) connector
Connects to the RS-485/422A connector of the
receiver (not supplied), or to the KBD I/F connector of
the CSPK-5000E System Keyboard (not supplied).
8 RS-232C connectors*

9 POWER switch

Turns on/off the power.
About 10 seconds after turning on the power, the
system will boot up and a buzzer sound will be heard.
0 AC IN socket
Connects to a power source of 220 to 240V AC, 50Hz.
!¡ EXT SYNC OUT (external sync output)
terminal
Outputs external VS signal that is input from the EXT
SYNC IN terminal.
If the VS signal is not input into the system controller,
this terminal outputs the internal reference signal or
the line-lock reference signal, neither of which include
a video signal.
* These connectors cannot be used.
!™ EXT SYNC IN (external sync input) terminal
Inputs external VS signal as a reference signal.
!£ EXT TIMING (external timing) connector (pin 1
to 32)
Inputs external timing pulse to switch cameras from an
external equipment. Normally connects to the time-
lapse VTR.
7(EN)