Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.1 C
3.1 c Preparation for mowing and mulching (where applicable)
•
In models with discharge potential: make sure the side discharge guard (4) is
lowered.
•
Lift the rear discharge guard (1) and fit the chute cap (5) in the discharge ope-
ning, keeping it slightly tilted to the right. Fasten it by fitting the two pins (6)
into the holes provided until the fastener tooth (7) clicks into place. To remove
the deflector cap (5), lift the rear discharge guard (1) and push in the middle
to release the tooth (7).
3.1 D
3.1 d Preparation for mowing and side discharge of grass (where applicable)
•
Lift the rear discharge guard (1) and fit the chute cap (5) in the discharge
opening, keeping it slightly tilted to the right. Fasten it by fitting the two pins
(6) into the holes provided until the fastener tooth (7) clicks into place.
•
Insert the side discharge chute (8) as shown in the figure.
•
Close the side discharge guard (4) so that the side discharge chute (8) is
locked in place.
To remove the deflector cap (5), lift the rear discharge guard (1) and push in the
middle to release the tooth (7).
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
