Cowling And Spinner Installation - Hangar 9 Tiger 30cc Bedienungsanleitung

6. Secure the fuel tank in the fuselage using hook and loop straps.
Use foam rubber under the tank to keep it from moving inside the
fuselage.
7. Remove the covering from the side of the fuselage for the fuel line
using a hobby knife and #11 blade. Route the line from one clunk
through the hole in the fuselage. Use the aluminum plug on the
outside of the fuselage.
8. Attach the remaining fuel line from the clunk to the carburetor. Use a
tie wrap to keep the fuel line secure.
 We highly recommend using a fuel filter between the fuel tank and
carburetor to prevent debris from entering the carburetor or engine.
EN

COWLING AND SPINNER INSTALLATION

 The recommended spinner cone has been prepared with
the propeller cutouts for the propeller. Most engines of
this size use multiple bolts to retain the propeller. Careful
positioning of the drilled holes is required to make sure the
propeller aligns with the cutouts in the spinner cone.
 We recommend preparing at least two propellers in case
a new propeller is required when out flying the model.
1. Place the washer from the engine (or a purpose made drilling jig)
on the spinner backplate. Use a stepped reamer to align the washer
with the spinner backplate. Mark the locations for the propeller
mounting screws using a felt-tipped pen.
2. Remove the washer from the backplate. Use a drill and 7/32-inch
(5mm) drill bit to drill the holes for the propeller mounting screws.
 A drill press is highly recommended for drilling
the holes to guarantee the holes are properly
aligned when installing the propeller.
3. Use a stepped reamer or bolt through the spinner back plate and
propeller to hold them in alignment so the bolt holes for attaching
the propeller can be marked. Use the screws from the spinner to
secure the spinner cone to the back plate. Position the propeller so it
does not contact the spinner cone. Use a felt-tipped pen to mark the
propeller for the mounting bolt locations.
 It may be necessary to trim the spinner cone to clear
the propeller depending on the choice of propellers.
4. Disassemble the spinner and remove the propeller. Use a drill and
7/32-inch (5mm) drill bit to drill the holes in the propeller for the
mounting screws.
 A drill press is highly recommended for drilling
the holes to guarantee the holes are properly
aligned when installing the propeller.
26