Receiver And Receiver Battery Installation - Hangar 9 Tiger 30cc Bedienungsanleitung

6. Apply a drop of light machine oil on the axle.
7. Slide the wheel on the axle. Secure the wheel using a wheel
collar and 6-32 x 1/4 inch socket head cap screw. Place a drop of
threadlock on the threads of the screw before tightening it using a
7/64 inch hex wrench.
8. Attach the landing gear to the fuselage using four 6-32 x 3/4 inch
socket head cap screws, four #6 washers and four #6 lock washers.
Apply a drop on the threads of each screw before threading them
through the landing gear and into the blind nuts. Tighten the screws
using a 7/64 inch hex wrench.
 The landing gear will angle forward slightly when installed.
9. Attach the wheel pants to the landing gear using two 4-40 x 1/2 inch
machine screws and two #4 washers. Apply a drop of threadlock on
the threads of each screw before tightening them using a #1 Phillips
screwdriver.
Tiger 30cc ARF

RECEIVER AND RECEIVER BATTERY INSTALLATION

1. Install the receiver in the fuselage. Mount any remote receivers in
the fuselage using hook and loop tape.
 Apply a small amount of 5-minute epoxy to the hook
and loop tape to secure it to the radio tray.
2. Secure the receiver battery in the fuselage. The battery location can
be changed to help in adjusting the Center of Gravity.
3. Remove the covering for the switch using a hobby knife with a
#11 blade. Use the opening that best fi ts the switch for your radio
system. Secure the switch in the side of the fuselage.
17 EN