Removing Wrinkles; Building Precautions; Transportation And Storage; Replacement Covering - Hangar 9 Tiger 30cc Bedienungsanleitung

REMOVING WRINKLES

The covering of your model may develop wrinkles during shipping. Use a covering iron (HAN101) with a sealing iron
sock (HAN141) to remove them. Start with a lower heat setting and use caution while working around areas where
the colors overlap to prevent separating the colors. It is also advised to use caution around the canopy as it is plastic
and could distort with excessive heat. Avoid using too much heat, which could also separate the colors. Placing a cool
damp cloth on adjacent colors will also help prevent the separation of the colors while removing wrinkles. Only use a
heat gun (HAN100) once the covering iron has been used.

BUILDING PRECAUTIONS

Prepare the work surface prior to beginning the build. The surface should be soft and free of any sharp objects. We
recommend resting the airframe parts on a soft towel or pit mat to prevent scratching or denting the surface of the
aircraft.

TRANSPORTATION AND STORAGE

When transporting and storing your model, you will need a minimum of 80 inches (2.1m) in length, and 19 inches
(50cm) in height to accommodate the size of the fuselage. We also recommend the use of wing and stabilizer bags to
help protect these surfaces during transport and storage. The control horns and linkages can cause damage to other
surfaces even when placed in storage bags. Always transport and store the wings and stabilizer so the linkages do not
contact other panels to prevent damage.

REPLACEMENT COVERING

Your model is covered with MonoKote® fi lm in the following colors. If repairs are required, order these coverings to
make those repairs.
TOPQ0201 Red
TOPQ0204 White
TOPQ0226 Sapphire Blue
TOPQ0205 Aluminum

CHECKING BLIND NUTS

When building the aircraft, you will be required to thread machine screws into blind nuts. We recommend pre-threading
the screws to make sure the blind nuts are clear of any debris. If the screws do not thread in easily, clear the threads
using the appropriate tap and tap handle.

FOR THE VISUALLY CHALLENGED

A copy of this manual can be found at www.horizonhobby.com under the tab for this particular model. Feel free to
download this manual and use a PDF viewer to zoom in on any text or images that may be in question when building
from the printed manual.
Tiger 30cc ARF

AILERON SERVO INSTALLATION

1. Use a hobby knife with a #11 blade to remove the covering on the
top of the wing near the wing root for the servo leads.
2. Use a hobby knife with a #11 blade to remove the covering on the
bottom of the wing for the servo opening.
3. Install the grommets and eyelets in the servos. Follow any
instructions included with the servo.
4. Center the aileron servo using the radio system. Place a servo arm
on the aileron servo perpendicular to the servo centerline. Use side
cutters to remove and arms that may interfere with the operation of
the servo.
5. Prepare both the left and right aileron servos.
5 EN