Hangar 9 Tiger 30cc Bedienungsanleitung Seite 19

STEP 2
10. Mix 1/2 ounces (15mL) of 30-minute epoxy. Use an epoxy brush to
apply epoxy to one of the top/bottom plates. Apply epoxy to the top/
bottom plate.
11. Place a second top/bottom plate in position. Repeat until the second
set of side plates and top/bottom plates have been positioned.
12. Use low-tack tape to hold the motor box together until the epoxy
cures. Use a paper towel and isopropyl alcohol to remove any
excess epoxy.
 It is critical to remove all excess epoxy or the
remaining pieces will not fit into position.
STEP 3
13. Mix 1/2 ounces (15mL) of 30-minute epoxy. Apply epoxy to a single
square end plate.
14. Place the square end plate in position. Repeat for the fi nal square
end plate.
Tiger 30cc ARF
15. Use low-tack tape to hold the motor box together until the epoxy
cures. Use a paper towel and isopropyl alcohol to remove any excess
epoxy. Allow the epoxy to fully cure before proceeding.
 Use medium grit sandpaper to sand the motor
box if necessary for a finished took.
19 EN