THERMEx Optica/Décor 660 Bedienungsanleitung Seite 25

Potential Problems and Solutions
If any problem occurs, please remove the plug from the socket and contact the nearest
maintenance centre or call an authorized person to effect any repairs.
Problem
Light on, but motor
does not work.
Light does not work,
motor does not work.
Oil leakage.
Body shaking.
Insufficient suction.
The machine inclines.
Cause
The leaf blocked.
The capacitor damaged.
The motor jammed
bearing damaged.
The internal wiring of motor off
or a bad smell from the motor.
Beside the above mentioned, check the following:
Light damaged.
Power cord looses.
One way valve and the air
ventilation entrance are
not tightly sealed.
Leakage from the connection of
U-shaped section and cover.
The leaf damaged and
caused shaking.
The motor is not tightly locked.
The body is not tightly hanged.
The distance between the body
and the gas top too long.
The Hood may be installed too
close to windows or doors which
when open may cause excessive
wind interference.
The loose of the fixing screw.
The loose of the hanging screw.
Solution
Get rid of the blocking.
Replace capacitor.
Replace motor.
Replace motor.
Replace lights.
Connect the wires as per the
electric diagram.
Take down the one way valve
and seal with glue.
Take U-shaped section down and
seal with soap or paint.
Replace the leaf.
Lock the motor tightly.
Fix the body tightly.
Readjust the distance.
Choose a new place and
reinstall the machine.
Fix tightly the hanging screw and
make it horizontal.
Fix tightly the hanging screw and
make it horizontal.
English
25