CleanCraft HDR-K 51-16 Übersetzung Der Originalanleitung Seite 21

3.2.8
W . High pressure may cause parts to rebound: wear all the protective
Arning
clothing (PPE) and equipment needed to ensure the operator's safety.
3.2.9 W . Before doing work on the appliance, REMOVE the plug.
Arning
3.2.10 W . Before pressing the trigger, GRIP the gun firmly to counteract
Arning
the recoil.
3.2.11 W . COMPLY WITH the local water supply authority regulations.
Arning
Under IEC 60335-2-79, the appliance may only be connected to the mains
drinking water supply if the supply hose is fitted with a backflow preventer
valve with drain facility corresponding to EN 12729 type BA. The backflow
preventer can be ordered from the manufacturer.
3.2.12 W . Water that has passed through backflow preventers is considered
Arning
to be non-potable.
3.2.13 W . Maintenance and/or repair of electrical components MUST be
Arning
carried out by qualified staff.
3.2.14 W . DISCHARGE residual pressure before disconnecting the hose from the
Arning
appliance.
3.2.15 W . CHECK before each use and at regular intervals that the screws
Arning
are fully tightened and that there are no broken or worn parts.
W . ONLY USE detergents which will not corrode the coating
3.2.16
Arning
materials of the high pressure hose / electric cable.
3.2.17 W . ENSURE that all people or animals keep a minimum distance of
Arning
16 yd. (15m) away.
3.2.18 W . This appliance is designed for use with the detergent supplied
Arning
or recommended by the manufacturer. The use of other detergents or
chemicals may adversely affect the appliance's safety.
3.2.19 W . Do not allow the detergent to come into contact with the skin,
Arning
and the eyes in particular! In case of contact with eyes, rinse with plenty of
water and seek medical advice at once!
21