Garmin GHC 10 Installation Seite 6

3. Drill
EN
4. Use the two included mounting screws to
attach the cradle to the mounting surface.
To attach the belt-clip button and belt clip:
1. Screw the belt-clip button into the back of the
cradle.
2. Snap the button into the belt clip or other
carrying accessory (sold separately).
Using the GHC 10 Remote
Control Lanyard
Use the GHC 10 Remote Control lanyard to carry
the GHC 10 Remote Control. The remote control
can still be placed in the cradle with the lanyard
installed.
To attach the lanyard to
the remote control:
1. Thread the thin loop on
the lanyard through the
eyelet on the bottom of
the remote control.
2. Thread the larger part
of the lanyard through
the thin loop and pull
until it is snug.
EN–
/ in. (3.2 mm) pilot holes.
1
8
Instructions