Garmin GHC 10 Installation Seite 5

To remove the remote control from the
cradle:
1. Push up on the bottom of the remote control to
release it from the cradle.
2. Pull the remote control out of the cradle.
Mounting the GHC 10 Remote
Control Cradle
You can either mount the GHC 10 Remote Control
cradle on a surface such as the dashboard of your
boat or install a button on the back to be used with
a belt clip (included) or other carrying accessories
(sold separately).
To surface-mount the
cradle:
1 Mount the cradle
9 / in. (250 mm) from
7
8
a magnetic compass to
avoid interference.
2. Using the cradle as a
template, mark the pilot
hole locations on the
surface on which you will
be mounting the cradle.
Note: If you are mounting the cradle in
fiberglass, it is recommended to use a countersink
bit to drill a clearance counterbore through only
the top gel-coat layer. This will help to avoid any
cracking in the gel-coat layer when the screws are
tightened.
Instructions
Attach belt clip button Attach belt clip button
Mounting screw holes Mounting screw holes
EN
EN–