Installation - Garmin GHC 10 Installation

EN
Installing Batteries in the
GHC 10 Remote Control
The GHC 10 Remote Control requires two AA
batteries.
To install batteries in the remote control:
1. Remove the battery cover by lifting and turning
the locking ring counter-clockwise.
2. Insert the batteries according to the diagram on
the remote control.
Using the Garmin GHC 10
Remote Control Cradle
The GHC 10 Remote Control cradle holds the
GHC 10 Remote Control, and can either be
mounted on a surface such as the dashboard or
connected to a belt clip.
To insert the remote
control into the cradle:
1. Slide the remote control
into the top of the cradle.
2. Push the remote control
into the cradle until you
feel it lock in place.
EN–

Installation

Instructions