All Models - Hatco GLO-RAY GRPWS-Serie Inbau- Und Betriebshandbuch

INSTALLATION

ALL MODELS

Glo-Ray Pizza Warmers are shipped with most components
pre-assembled. Care should be taken when unpacking shipping
carton to avoid damage to unit and components enclosed.
1. Remove unit from box.
2. Remove information packet. To prevent delay in obtaining
warranty coverage, fill out and mail in the warranty card.
3. Remove tape and protective packaging from all surfaces
of unit.
4. Carefully lay unit on its side and install the four legs,
See 6 . Hand tighten legs until snug.
CAUTION
The National Sanitation Foundation (NSF) requires that
GRPWS Series units over 91 cm (36") in length or weighing
more than 36 kg (80 lbs.) to be either sealed or raised
on the installation surface. If this unit cannot be sealed
at the point of use, 10 cm (4") legs are included to allow
for proper cleaning access below unit. See Hatco Accessories
for installation instructions.
MODELS WITH 10 CM (4") ADJUSTABLE LEGS
5. Carefully lay unit on its side. Install legs to bottom of unit,
6
See . Hand tighten legs until snug. Do not overtighten.
Return unit to the upright position.
NOTE: Legs are adjustable for leveling the unit. Use a 16 mm
(5/8") open-end wrench to make leveling adjustments once the unit
is placed in final position.
OPERATION
Plug unit into an electrical outlet of the correct voltage, size
and plug configuration. See SPECIFICATIONS for details.
Each shelf on the unit is controlled by an ON/OFF switch and
9
thermostat control. See . The switch for each shelf must be
in the ON position for that shelf to function. The thermostat control
for each shelf can be set to any desired heating level as indicated
on the control plate.
Form No. GRPWSCEM-0702
6. Slide each side glass panel into the upper channel, then lower
the panel into the lower channel. See
7. Each unit is supplied with a stainless steel box stop for each
shelf. To install, place the box stop in the holding brackets and
twist down until secure. See
LOCATION
NOTE: The unit must be transported in the upright position.
For proper operation and maximum performance, locate the Pizza
Warmer in an area where the ambient air temperature is constant
and is a minimum of 21°C (70°F). Areas which are susceptible
to active air movements or currents should be avoided, i.e., near
exhaust fans or hoods and air conditioning ducts.
For safe and proper operation, the unit must be located
a reasonable distance from combustible walls and materials.
If safe distances are not maintained, discoloration
or combustion could occur.
Locate the unit at the proper counter height, in an area that
is convenient for use. The location should be level to prevent
the unit or its contents from accidentally falling, and strong
enough to support the weight of the unit and food displayed.
Some exterior surfaces on the unit will get hot. Use caution
when touching these areas to avoid injury.
7
.
7
8 .
WARNING
CAUTION
CAUTION