diagral DO200 Bedienungsanleitung Seite 28

Programming the group
I
When you take the detector out of its packing, the programmed group is "group 1".
You may keep this programming or assign the detector another group out of the
4 proposed in the table below:
Group
with control panel in
Partial/Total mode
Active in Partial and Total
Operation
Group 1
Immediate tripping
Active in Partial and Total
Operation
Group 2
Immediate or delayed tripping
Active in Total Operation
Inactive in Partial Operation
Group 3
Immediate tripping
Active in Total Operation
Inactive in Partial Operation
Group 4
Immediate or delayed tripping
ssign the detector the chosen group by programming the relevant code (series of 3
digits made up of "0" and "1"), pressing the keys as shown below:
Start of programming
0 1
0 1
Press both keys at
the same time until
the light indicator
goes out.
If during programming more than 7 seconds elapse between pressing
!
2 keys or if you do not press simultaneously or long enough keys 0 and 1 at
the beginning or end of programming, you will leave the programming mode. The
red light indicator then flashes to show that programming is not correct. The initially
programmed group is kept, and you must repeat the operation from the beginning.
Detector operation
0 1
0 1
Press both keys at
the same time again
until the light indicator
goes out
with control panel in
Independent Group mode
Active in ON Group 1+2
Immediate tripping
Active in ON Group 1+2
Immediate or delayed tripping
Active in ON Group 3+4
Immediate tripping
Active in ON Group 3+4
Immediate or delayed tripping
Programming
L
Briefly press the keys
3 times for your group
code. The light
indicator comes
on each time a
key is pressed.
Group Code
0
0
1
1
End of programming
0 1
0 1
Press both keys at the same time
until the light indicator goes out.
The light indicator then comes on
for 5 sec. to indicate that
programming is OK.
GB
0 0
1 0
0 0
1 0
28