diagral DO200 Bedienungsanleitung Seite 27

Caution: programming is not authorised if the detector is clipped onto its base.
Programme first the installation radio code, and then the group assigned to the detec-
tor, by pressing keys 0 and 1 in turn
Programming the installation radio code
I
You should code the control panel before the detector.
When you take the detector out of its packing, the installation radio code is blank (no
connections broken on the control panel).
On the 1st line of the table below tick the boxes corresponding to the control
1
panel coding template's installation radio code (one tick per broken hole).
customised radio code
detector code
On the 2nd line mark "0" (zero) below each tick
2
Enter "1" (one) in the empty boxes on the 2nd line.
3
You now have a series of 10 digits made up of "0" and "1" corresponding to your
detector's installation radio code.
Warning: code 0000000000 is not recommended.
Programme the radio code by pressing keys 0 and 1 on the detector as shown
4
below:
Start of programming
0 1
0 1
Press both keys at
the same time until
the light
indicator goes out.
If during programming more than 7 seconds elapse between pressing
!
2 keys or if you do not press simultaneously or long enough keys 0 and 1 at
the beginning or end of programming, you will leave the programming mode. The
red light indicator then flashes to show that programming is not correct. The initially
programmed code is kept, and you must repeat the operation from the beginning.
Installation radio code test
5
Briefly press the detector's test key and check that the control panel (already
coded) emits an audible signal and causes the indicator assigned to group 1 to
come on.
If the control panel does not properly respond, first recode the detector. Then if the
problem persists, recode the control panel and try again.
You have now assigned the detector its installation radio code.
1 2
Programming
L
Briefly press the keys 10 times for
your installation radio code. The red
light indicator comes on each time a
key is pressed.
3 4 5 6
End of programming
Press both keys at the same time
until the light indicator goes out.
The light indicator then comes on
for 5 sec. to indicate that
programming is OK.
GB
7 8 9 10
0 0 1 1
27