Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating Instruction
A professional starting-aid battery for daily
workshop use. The stand-out feature of this
EN
model is its hybrid construction, which has
2 different energy stores. In addition to featur-
ing a leak-proof, high-performance AGM bat-
tery, the Reanimator Hybrid is also equipped
with supercaps (ultracapacitors). The com-
bination of these energy stores enables a
very high inrush current – particularly in the
starting range. Furthermore, the capacitors
absorb the main loads, thus conserving the
battery. As such, they have a positive effect
on the battery's service life.
Hybrid construction, AGM + supercaps
On/Off switch prevents short-circuits
With acoustic warning for reverse polarity
With surge protection
With circuit breaker and fuse
High-performance clamps with earth strap
With an automatic high-frequency charger
which is suitable for permanent connection.
1.3 Technical data
Rated voltage:
12 V
Peak current:
3850 A
Inrush current:
1350 A
Battery:
AGM battery
Battery capacity:
22 Ah
Capacitor capacity:
600 F
Cable length:
80 cm
Cable cross-section:
25 mm²
Service life:
500 cycles
Weight:
11.7 kg
LED charge-level indicator
20 A circuit breaker
500 A fuse
CE-verified
www.herthundbuss.com
95980802
2. Safety information
Read all the instructions carefully before
using this product for the first time.
Always observe the general accident
prevention regulations and wear ap-
propriate personal protective equip-
ment, including safety goggles and
protective gloves.
The Reanimator and the charger are not
intended for use by children. People with
restricted physical, sensory or mental
capabilities, or who have insufficient ex-
perience and specialist knowledge, must
be supervised by a person responsible
for their safety whilst using the product.
Do not touch the inside of the device
with your fingers or hands.
Do not expose the Reanimator or the
charger to rain or snow.
Only use accessories which are appro-
ved by the manufacturer.
Do not use the Reanimator or the char-
ger if the output cable is damaged.
Do not use the Reanimator or the char-
ger if they have been subjected to a hard
impact, been dropped or been damaged
in any other way.
Do not dismantle the Reanimator or
the charger.
Operating Instruction
Working in the vicinity of lead-acid bat-
teries is dangerous. Batteries generate
explosive gases during normal operation
and while charging. Always ensure ade-
quate ventilation and avoid naked flames
and sparks for this reason. Naturally, this
also applies to smoking.
Ensure that the Reanimator and the
charger are placed on a dry, non-flam-
mable surface.
In order to minimise the risk of a battery
explosion, follow these instructions in
addition to those published by the bat-
tery manufacturer and the instructions
from the manufacturers of devices which
are intended for use in the vicinity of the
battery. Observe the safety notices on
these products and on the engine.
Attention: Do not use the Reanimator
with batteries which cannot be re-
charged. Only use the Reanimator with
rechargeable lead-acid batteries. Do
not use with dry cell batteries, such as
those often used in household appli-
ances. Such batteries can burst and
thereby cause physical injury or material
damage.
Remove all personal effects made from
metal, such as rings, bracelets, necklaces
and wristwatches, when working with a
lead-acid battery. A lead-acid battery can
generate a short circuit that is sufficiently
powerful to weld a ring or similar metal-
lic object, which can cause serious burn
injuries.
10
11
95980802
Exercise particular caution to prevent
metallic objects from falling onto the bat-
tery. These can cause sparks or short the
battery or other electrical components
and trigger an explosion.
To prevent sparks, ensure that the clamps
NEVER touch each other or come into
contact with the same metallic object.
3. Start-up
Inspect the device and the cables for visible
damage. The device's housing must not ex-
hibit any cracks or other types of damage.
The insulation of the cables and the battery
charger pliers must be intact.
WARNUNG
Attention:
The device must be charged before
and after every use.
Wherever possible, leave the Reanimator
connected to the charger when not in use.
This will considerably prolong the battery
life. Press the button for the charge-level in-
dicator to monitor the battery's charge level.
5 LEDs must light up. The voltage must be
more than 13.5 V in this case.
EN
Werbung
Inhaltsverzeichnis
