Fitting Instructions; General Information - Herth+Buss ELPARTS Einbauhinweis

Fitting Instructions

General information

EN
Suitable for single-circuit and dual-circuit signal systems
The warning light transmitters are suitable for installation in cars, trucks, buses and tractors
with and without trailers. For easier connection, a universal cable set with a common con-
nector is available under article number 70460001005. (available separately)
Fitting
1. Disconnect the battery
2. Install the warning light transmitter at a
suitable point in or under the instrument
panel. Connections must point down-
wards. Mounting hole = Ø 10.5 mm.
3. Connect the warning light transmitter and
wiring set.
4. Shorten the cables according to the in-
stallation conditions and connect to the
electrical system using standard connec-
tors. Route the cables according to the
colours specified in the circuit diagrams.
5. Reconnect the battery and check that the
IMPORTANT
Read carefully before use
Keep for later reference
The latest version of the Operating/
Fitting instructions is also available
in our online catalogue:
herthundbuss.com/online catalogue
www.herthundbuss.com
warning light system is working correctly.
The warning light system must light up all
four indicators simultaneously regardless
of the position of the direction switch or
the brake light switch. The red indicator
light in the control handle must also flash
in rhythm.
These installation instructions are non-bind-
ing. We recommend checking the installa-
tion options!
70460001
4