Thermalright TRUE Spirit 90 Direct Installationsanleitung Seite 9

Installation Instructions:
Step 1:
Step1 : Rubber Tubes Installation
Insert the four black Rubber Tubes (Noise damping use) into the four indents on the front of the heat-
sink body. Do not remove them.
Step 2:
Step 2 : Backplate Installation
Choose the platform AMD AM3/AM4 you are in use. Make four M3L10 Screw Pillars go through the
Metal Back Plate and the Mylar film from bottom towards top. And then place the Metal Back Plate on
the table. Put the four Washers (for AMD) around the Screw Pillars.
Step 3:
Step 3 : Back Plate Cap
Note: When installing on an AMD platform, please
first insert the Back Plate Cap into the opening on
the Metal Back plate, make sure you have the Cap
facing downwards.
The Ultimate Cooling Solutions!
Step 4:
1
3
Step 4 : Screw Cylinder Installation
Place the motherboard on top of the Back Plate.
See the four Screw Pillars go through the four
holes around the processor socket.Cap the four
Screw Pillars with the four Screw Nuts.Make sure
the side with a washer is facing the Back Plate.
www.thermalright.com
AM4
AM3
4
2
6