Operation For Epilation; Cleaning - Ideen Welt RAY-002 Bedienungsanleitung

=7?,--/@KHLQ -.-1.2

Operation for Epilation

‡ The Epilator can be used by either cord or cordless operation.
‡ For cord operation, make sure the device is off. Connect the power cord connection of the AC adap-
tor to the socket on the device.
‡ For cordless operation, make sure the device is fully-charged before use.
‡ Remove the protective cap from the unit.
‡ Check if the rotating epilator head has been installed on the unit.
‡ Stretch your skin with your free hand to make the hairs stand upright.
‡ Push the On/Off switch upward: the tweezers start rotating.
‡ 3ODFH WKH XQLW DW ƒ DQJOH RQWR \RXU VNLQ 3UHVV WKH XQLW OLJKWO\ RQ WR \RXU VNLQ 'R QRW H[HUW DQ\
pressure, just touch the skin. (Figure 1)
‡ Use short, circular movements as if you are brushing or wiping – in the direction the hair grows.
(Figure 2)
‡ Pull the skin taut with your other hand, if necessary. Stretch out your leg when removing hair behind
your knee. (Figure 3)
Figure 1
‡ Hold out your arm to stretch the skin when removing armpit hairs.
‡ To turn the device off, push the On/Off switch downward.

Cleaning

‡ Always switch off unit and unplug the adaptor from the mains before cleaning.
‡ Cleaning the unit after each use.
‡ Remove the rotating epilator head from the unit for cleaning.
‡ Use the cleaning brush (included) to remove all the hairs from the rotating head mechanism and the
housing.
‡ It is no need to clean the discs of the rotating mechanism. However, you can wipe them from time to
time with alcohol to maintain hygiene. Use a cotton bud which you have soaked in alcohol and then
squeezed out. The cotton bud must not be wet.
‡ Never put the appliance in water or any other liquid.
‡ Never use abrasive cleaners, brushes gasoline, kerosene, glass / furniture polish or paint thinner to
clean.
Figure 2
12
Figure 3