Siemens 7MF8 23-Serie Kompaktbetriebsanleitung Seite 4

Introduction
Purpose of this documentation
These instructions are a brief summary of important features, functions and safety information, and contain all information
required for safe use of the device. It is your responsibility to read the instructions carefully prior to installation and
commissioning. In order to use the device correctly, first review its principle of operation.
The instructions are aimed at persons who mechanically assemble the device, connect it electrically, and start it up.
To achieve optimum usage of the device, read the detailed version of the manual on the electronic data medium.
See also
Instructions and Manuals (http://www.siemens.com/processinstrumentation/documentation)
History
This history establishes the correlation between the current documentation and the valid firmware of the device.
Currently released versions of these instructions:
Edition Firmware identifier nameplate
08/2011 HART: FW: 29.03.07
PA/FF: FW: 0300.01.08
up to SP05 Hotfix 5
1)
Purpose
Overview
Depending on the version, a transmitter measures corrosive, non-corrosive and hazardous gases, vapors and liquids.
You can use the transmitter for the following types of measurement:
● Gauge pressure
● Absolute pressure
With appropriate parameter settings and the necessary add-on parts (e.g. flow orifices and remote seals), the pressure
transmitter can also be used for the following measurements:
● Level
● Volume
● Mass
The output signal is a load-independent direct current of 4 to 20 mA which is linearly proportional to the input pressure.
The "Intrinsically-safe" version of the transmitter can be installed in hazardous areas (zone 1). The devices have an EC type
examination certificate and comply with the appropriate harmonized European CENELEC directives.
Operate the device in accordance with the specifications in Section Technical data (Page 25).
For additional information, please refer to the operating instructions for the device.
Checking the consignment
1. Check the packaging and the device for visible damage caused by inappropriate handling during shipping.
2. Report any claims for damages immediately to the shipping company.
3. Retain damaged parts for clarification.
4. Check the scope of delivery by comparing the shipping documents with your order for correctness and completeness.
4
System integration
PDM 6.0 ; Dev. Rev. 3
1)
DD Rev. 2
Installation path for PDM
SITRANS P300
© Siemens Ⓟ2011
A5E03434657-01, 08/2011