Control - Menus - Nibe Rmu S40 Installateurhandbuch

Control – Menus
MENU – HOME SCREENS
HEATING
HEAT HEAT
Living room Kitchen
You make temperature settings for your installation here.
If the house has several climate systems for heating,
this is indicated on the display with a function page for
each system. You can browse between the various cli-
mate systems (up to 8).
Setting the temperature (without controlling room
sensor activated):
Setting range: -10 to +10
The display shows the set values for heating (curve
offset). To raise or lower the indoor temperature, in-
crease or reduce the value on the display.
1. Browse to the function page.
2. Press the screen with your finger.
3. Select the required offset.
4. Save by pressing the green button.
The number of steps the value has to be changed in
order to achieve a one degree change to the indoor
temperature depends on the heating installation. One
step may be sufficient for underfloor heating, while radi-
ators may require three.
Setting the temperature (with controlling room
sensor activated):
Setting range: 5 – 30 °C
The value on the display appears as a temperature in °C
if the heating system is controlled by a room sensor. To
change the room temperature, increase or reduce the
value on the display.
Browse to the function page.
1.
Press the screen with your finger.
2.
3. Select temperature:
4. Save by pressing the green button.
26
Caution
An increase in the room temperature can be
slowed by the thermostats for the radiators or
underfloor heating. Therefore, open the ther-
mostat valves fully, except in those rooms
where a cooler temperature is required, e.g.
bedrooms.
TIP
Wait 24 hours before making a new setting,
so that the room temperature has time to sta-
bilise.
Displaying
• current indoor temperature if the indoor sensor or
wireless sensor/thermostat is connected to the relev-
ant climate system.
• required indoor temperature
• current set offset
• all installed climate systems (up to 8)
• controlling wireless temperature sensors and/or ther-
mostats
• status if you are currently operating prioritised heating.
COOLING
COOLING
Kitchen
You make temperature settings for RMU S40 here.
If the house has several climate systems for cooling,
this is indicated on the display by a function page for
each system. You can browse between the various cli-
mate systems (up to 8).
Setting the temperature (without controlling room
sensor activated):
Setting range: -10 to +10
The display shows the set values for heating (curve
offset). To raise or lower the indoor temperature, in-
crease or reduce the value on the display.
1. Browse to the function page.
NIBE RMU S40 | GB