Sound Settings - Sony FWD-40LX2F Bedienungsanleitung

Sound Settings

Sound
Sound Mode : Dynamic Dynamic
Sound Mode Reset Standard
Treble : SRS WOW
Bass : Custom
Balance : Center
Common Audio Sel. : HD15
Speaker Out : On
Sel : :
Set
Sound Mode
Sound Mode Reset
Treble
Bass
Balance
Common Audio Sel.
Speaker Out
Tip
You can adjust the sound quality menus ("Treble" and "Bass") when the "Sound Mode" is set to "Custom".
24
GB
HDMI 1
Back: Exit:
MENU
"Dynamic": Select to enhance treble and bass.
"Standard": Flat setting.
"SRS WOW": Provides a panoramic stereo audio image by producing deep and rich
bass tones and clear treble tones, enabling you to enjoy powerful sound effects like
those in a movie theater.
"Custom": Allows you to store preferred settings.
Tips
• To change from one "Sound Mode" option to another, you can also use SOUND on the
remote control instead.
• The proprietary technologies of BBE Sound, Inc. are applied for "Dynamic" and "Standard".
Resets the following settings; "Treble", "Bass" and "Balance" to the default settings.
Adjust to increase or decrease higher-pitched sounds.
Adjust to increase or decrease lower-pitched sounds.
Adjust to emphasize left or right speaker balance.
"HD15": Outputs audio from a piece of video equipment or PC connected to the
HD15 (RGB/COMPONENT IN) connector and the AUDIO (COMMON AUDIO
IN) connector.
"HDMI 1"/"HDMI 2": Select to connect a piece of equipment using an HDMI cable
(not supplied) or an HDMI-to-DVI cable, and the corresponding audio cable at the
same time.
See page 8.
Notes
• When using an HDMI-to-DVI cable (not supplied), connect the audio cable to the AUDIO
(COMMON AUDIO IN) connector.
• When "HDMI 1"/"HDMI 2" is selected, digital audio is not output from the HDMI
connectors. When a piece of video equipment equipped with an HDMI connector is
connected to the HDMI 1/HDMI 2 connectors, set "Common Audio Sel." to "HD15".
(The default setting is "HD15".)
"On": Enables sound to be emitted from the speakers.
"Off": Disables sound to be emitted from the speakers.
Note
When "Speaker Out" is set to "Off", "Sound Mode", "Sound Mode Reset", "Treble", "Bass",
and "Balance" cannot be selected.
When the speakers SS-SP40FW/32FW (not supplied)
are installed, you can set various "Sound" settings.
To highlight an option and to change settings, press
F f G g
/ / / .
Press to confirm the selection.
The "Sound" settings include the following options: