Upwards / Downwards (Throttle); Hang Left / Right (Roll); Move Forwards / Backwards (Pitch); Turn Left / Right (Yaw) - DELTA-SPORT 285746 Gebrauchsanweisung

Upwards / downwards (throttle)

(figure J)
By moving the throttle (2d) forwards the speed of
the rotors increases. The quadrocopter begins to
rise.
By moving the throttle backwards the speed of the
rotors decreases. The quadrocopter begins to sink.
Hang left / right (roll) (figure K)
If you want to carry out a manoeuvre hanging to
the right or left without turning the quadrocopter,
producing a hang to the side, then move the right
joystick (2e) to the left or right. The further you
steer the joystick the faster the sideways movement
will occur.

Move forwards / backwards (pitch)

(figure L)
The quadrocopter will move in the corresponding
direction when you move the right joystick (2e)
forwards or backwards. The further you steer the
joystick in the corresponding direction the faster
the quadrocopter will fly.
Turn left / right (yaw) (figure M)
By moving the throttle (2d) to the left or right you
can turn the quadrocopter around its vertical axis,
i.e. the quadrocopter rotates in place to the right
and left. The further you move the throttle the
faster it will turn.
360° rollover (figure N)
1. Steer the quadrocopter (1) to a height of
approx. 4m.
2. Hold it at a hover and press the button (2c) one
time. A signal will sound.
3. Move the joystick (2e) in the direction in which
you want to fly the rollover.
4. The quadrocopter will perform a 360°

rollover.

After the rollover the quadrocopter is in normal
flying mode and you can repeat a further rollover.
Press the button again if you decide not to per-
form a rollover and had already pressed it.
Note: You need sufficient flying height (at least
4metres) for a 360° rollover.
Setting the speed (figure O)
You can set the flying speed on the remote control
(2) by pressing the buttons 2f, 2g, and 2h.
The basic setting is the lowest speed of a total of
three speed levels. The speed level is shown on
the speed display (2i).
Speed level 1 (2h) (beeps once)
Speed display (2i) lights up in the lower area.
For the first attempts and if you have little expe-
rience flying.
Speed level 2 (2g) (beeps twice)
Speed display (2i) lights up in the middle area.
For pilots with first experience flying.
Speed level 3 (2f) (beeps three times)
Speed display lights up in the upper area (2i).
For very experienced pilots.
Note: When you switch the remote control off
and on again the quadrocopter will be set back at
speed level 1.
LED position lamps (figure P)
Press button (2b) to switch the LED position lamps
on or off.

Direction (roll and pitch trimming)

(figure Q)
If a forward or backward movement occurs even
though you are not using the joystick then you can
control this using pitch trimming.
If the quadrocopter flies forwards then press the
pitch-trim button (2m) backwards and vice versa.
You will counteract the undesired movement with
this trim setting.
If the quadrocopter is moving sideways on its own
then you can correct this using roll trimming.
If the quadrocopter is hanging sideways to the
left then press the trimming button (2n) to the right
and vice versa. Thus you are counteracting the
undesired movement.
Calibration (figure R)
It is possible that the quadrocopter starts flying
uncontrollably and needs to be calibrated. For this
proceed as follows:
1. Place the quadrocopter (1) on a horizontal
and level area.
2. Simultaneously push the throttle (2d) and the
joystick (2e) downwards and to the right.
The LED position lamps (1b) on the quadro-
copter will flash for approximately 3 seconds.
As soon as they stop flashing the calibration is
finished and the quadrocopter is ready to fly.
GB 17