Waeco PerfectView CAM60 Einbau- Und Bedienungsanleitung Seite 32

_CAM60.book Seite 32 Dienstag, 22. Dezember 2009 5:02 17
Mounting the camera
Creating a through-hole for the camera connection cable
(fig. d, page 5)
NOTE
I
If possible, use available openings – such as ventilation grilles – to
feed the connection cables through. If there are no existing open-
ings, you must drill a hole with a 20 mm diameter.
NOTICE! Risk of damage!
A
Ensure that there is sufficient space on the other side for the drill
head to come out
➤ Drill a hole of Ø 20 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place cable sleeves in all sharp edged ducts.
Mounting the camera
NOTICE! Risk of damage!
A
Only use the screws supplied to mount the camera in the camera
bracket. Longer screws will damage the camera.
➤ Push the camera into the camera bracket.
➤ Attach the camera loosely with the two screws M3 x 6 mm in the slots
(fig. e, page 5).
➤ Align the camera provisorily so that the lens is at an angle of approx. 50°
to the perpendicular axis of the vehicle (fig. f, page 6).
NOTICE! Risk of damage!
A
Never mount the camera without the camera guard.
32
PerfectView CAM60