_CAM60.book Seite 29 Dienstag, 22. Dezember 2009 5:02 17
PerfectView CAM60
8
Mounting the camera
8.1
Tools required
For installation and assembly you will require the following tools:
Drill bit set (fig. 1 1, page 2)
Drill (fig. 1 2, page 2)
Screwdriver (fig. 1 3, page 2)
Set of ring or open-ended spanners (fig. 1 4, page 2)
Measuring ruler (fig. 1 5, page 2)
Hammer (fig. 1 6, page 2)
Centre punch (fig. 1 7, page 2)
To make and test the electrical connection, the following tools are required:
Diode test lamp (fig. 1 8, page 2) or voltmeter (fig. 1 9, page 2)
Insulating tape (fig. 1 11, page 2)
Cable bushing sleeves, if necessary
To fasten the cables you may require additional cable binders.
Mounting the camera
29