I Remote Control - Panasonic CS-C12ATP5 Bedienungsanleitung

NAME OF EACH PART

I Remote Control

1
2
FAN
AUTO
SPEED
C
COOL
DRY
H H
FAN OFF ON OFF ON
3
TEMP OFF/ON
MODE SLEEP FAN SPEED
4
5
AUTO
6
TIMER AIR SWING
7
OFF/ON SET/C MANUAL
RESET
G Remote Control Signal.
• Make sure it is not obstructed.
• Maximum distance : 10 m.
• Signal received sound.
One long beep or "beep, beep" .
G Notes for Remote Control.
• Do not throw or drop.
• Do not get it wet.
• Certain type of fluorescent lamps may affect
signal reception. Consult your dealer.
G Do not place the remote control in a location exposed
to direct sunlight, or next to a heating unit, or other
heat source.
1 Signal Transmitter
2 Operation Display
Cooling Model
AUTO
C
COOL
DRY
H
FAN OFF ON OFF
8
Heat Pump Model
9
AUTO
C
HEAT
!
COOL
H
"
DRY
OFF ON OFF
#
3 Room Temperature Setting Button
$
(self-illuminating button)
4 Operation Mode Selection Button
5 Sleep Mode Operation Button
(self-illuminating button)
6 Timer Setting Button
7 Timer Selection Button
8 OFF/ON Button
(self-illuminating button)
9 Fan Speed Selection Button
0 Auto Airflow Direction Button
! Timer Set/Cancel Button
@ Manual Airflow Direction Selection Button
# Reset Point
(Press with fine-tipped object to clear the memory)
FAN
SPEED
H
ON
FAN
SPEED
H
ON
G How to Insert the Batteries
1
1
Gently press the place marked OPEN and slide
the cover towards you.
2
Insert the batteries
– Be sure the direction is correct.
G About the batteries
• Can be used for approximately one year.
G Observe the following when replacing the batteries
• Replace with new batteries of the same type.
• Do not use rechargeable batteries (Ni-Cd).
• Remove the batteries if the unit is not going to be
used for a long period.
G Proper way to operate the remote control in the
case of ceiling/wall mounting.
• Operate the remote control in parallel with the floor.
(See the figure below)
(Fig. 1) Horizontal Level
• The signal changes as shown in the figure below.
It means that the receiving conditions are bad and
the signal can not be controlled properly.
(Fig. 2)
2
O.K.
OUT
4