Standard Accessories; Optional Accessories; Installation; Assembling The Accessories - EMAK PW170C Bedienungsanleitung

• If the identification label and the warning labels deteriorate during use, contact your dealer or an authorised
service centre so they can be replaced.
3.2 s a
tandard
Make sure that in the product package that was bought there are the following elements:
• high-pressure water cleaner;
• high-pressure delivery pipe with fast coupling (only PW 160 - IP 1600);
• hose reel complete with high-pressure delivery pipe (only PW 160C - PW 170C - IP 1700S);
• water gun;
• lance hose;
• rotojet (only PW 160C - PW 170C - IP 1700S);
• foaming lance (only PW 160 - PW 160C - IP 1600);
• operator's instruction book;
• accessory bag containing:
- lance hose nozzle disassembling wrench,
- nozzle cleaning pin,
- water suction hose-holding connector,
- water suction filter;
• bag containing (only PW 160C - PW 170C - IP 1700S):
- knob and lever for hose reel (13),
- water cleaner/hose reel connecting pipe (25),
- accessory support (26).
In case of problems, apply to the dealer or to an authorised service centre.
3.3 o a
ptIonal
The standard accessories for the high pressure cleaner can be integrated with the following vast range of accessories:
• Sandblasting lance: designed for smoothing down surfaces, eliminating rust, paint, deposits etc.
• Pipe-draining probe: designed for unblocking pipes and ducts.
• Underbody lance: designed to reach the most difficult areas of access.
• Rotating water jet brush: designed for cleaning delicate surfaces.
• Rotojet: designed to eliminate the toughest dirt.
• Foaming lance: designed for the most efficient distribution of detergent.
WArnInG
• The operation of the water cleaner may be impaired if unsuitable accessories are used and they may even make
it dangerous. Only use original accessories endorsed by the Manufacturer.
Refer to the documents provided with the optional accessories for information regarding their general use, safety
warnings, installation and maintenance.
4 I
nstallatIon
See Fig. A at the front of these operating and maintenance instructions.
4.1 a
ssemblInG
a) Insert the lance hose (11) on the water gun (8) and tighten.
b) Mount the accessory support (26) on the handlebar (30); mount the knob and the lever (13) on the hose reel (6)
(only PW 160C - PW 170C - IP 1700S).
c) Mount the hose (25) between the hose reel and the water cleaner, by tightening the two fast coupling connectors;
unroll the hose quantity (7) that is necessary by rotating the hose reel by means of the knob (13) (only PW 160C -
PW 170C - IP 1700S).
d) Unroll the high-pressure hose (7), connect the fast coupling connector to the water outlet connector (5), screw and
tighten (only PW 160 - IP 1600).
e) Screw the end of the high-pressure pipe (7) (side without fast coupling for PW 160 - IP 1600) on the water gun
thread (8) and tighten with two 17-mm box wrenches (not supplied).
f) Insert the water suction filter (15) into the water suction connector (14) and tighten it on the water inlet connector
of the water cleaner.
20
CCessorIes
CCessorIes
a
the CCessorIes