Vitrifrigo CENTER COOLER Installation Bedienung- Und Wartungsanleitung Originalanleitung Seite 13

Temperature setting
To set the desired temperature, push the button until you see the
current set point value flashing, then adjust the value using the button
(increase) and (decrease); to store the new value press the button
.
NOTE: To ensure that the milk is always maintained at temperature
allowed by the HACCP, the setpoint can be varied only within a specific
values range.
NOTE: The refrigerator can operate at lower temperatures than the level
obtained, by setting the thermostat to lower setpoint values. However,
since these temperatures are out of the envisaged range for storing milk
or similar liquids for human consumption, the manufacturer advises
against using the refrigerator in this way, stressing again that the
appliance is designed and made to store milk or similar liquids for human
consumption at a controlled temperature and not to chill such products
from room temperature.
Milk level sensor functioning
The refrigerator is provided with one milk level sensor which detects the
presence of milk in the container and generates an alarm when the level
falls below about 0.5 litres of milk. The refrigerator can be provided also
with two milk level sensors (optional) to be used with milk tank with wall
divider (for two milk kind).
The refrigerator needs to be connected to the coffee machine, the milk
level alarm will be shown on the coffee machine display.
NOTE: This refrigerator is designed to work with a full milk container
placed inside it. In this way, if the refrigerator is working without the
container or with a small amount of milk, the alarm will activate.
Refrigerator switch off
To switch off the refrigerator hold the button for at least 3 seconds.
171209 – rev. 01 08/18 EN