Fcc Information - NEC MultiSync series Bedienerhandbuch

FCC Information

1. Use the attached specified cables with the N0501/N0701/N9902
color monitor so as not to interfere with radio and television
reception.
(1) Please use the supplied power cable or equivalent to ensure
FCC compliance.
(2) Shielded captive type signal cable.
Use of other cables may cause interference with radio and
television reception.
2. This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy, and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult your dealer or an experienced radio/TV technician for help.
If necessary, the user should contact the dealer or an experienced radio/
television technician for additional suggestions. The user may find the
following booklet, prepared by the Federal Communications Commission,
helpful: "How to Identify and Resolve Radio-TV Interference Problems".
This booklet is available from the U.S. Government Printing Office,
Washington, D.C., 20402, Stock No. 004-000-00345-4.
00Cover_all.p65 2 03.11.2000, 14:39 Uhr