90°-Trapezeckteil
DEUTSCH
5.1
Maximale Beladung
Gefahr!
Maximale Gesamtbeladung des
Eckteils beachten: 75 kg
5.2
Kabelwanne
•
Kabelwanne an hintere Profile schrauben
(3.2).
•
Kabelwanne an Ausleger und Stütze
schrauben (3.2).
Hinweis
Bei der Verkabelung Zugentlastung und
Kabeleinführungs-Set montieren!
5.3
Rahmen und Profile
Rahmen an hintere Profile und
Stütze schrauben
A
A
•
Bei Bedarf Ausgleichsplättchen montieren
(3.3).
Vordere Profile
•
Vordere Profile an Rahmen schrauben
(3.4).
18
90° trapezoidal corner
ENGLISH
Maximum load
Danger
Do not exceed the maximum load
of the corner: 75 kg
Cable tray
•
Bolt the cable tray to the rear sections
(3.2).
•
Bolt the cable tray to the arm and
support (3.2).
Information
Fit the strain-relief clamp and cable inlet
set for cables.
Frame and sections
Bolt the frame to the rear sections
and support
A
A
A
8
A2
A3
•
Fit adjusting plates if necessary (3.3).
Front sections
•
Bolt the front sections to the frame (3.4).
Elément d'angle
trapezoïdal à 90°
FRANÇAIS
Charge maximale
Danger !
Respecter la charge maximale
d'élément d'angle : 75 kg
Goulotte à câbles
•
Visser la goulotte à câbles sur les profilés
arrière (3.2).
•
Visser la goulotte à câbles sur la traverse
et sur le montant (3.2).
Nota
Monter la décharge de traction et le kit
d'entrée de câbles lors du câblage !
Châssis et profilés
Vissage du châssis sur les profil és
arrière et sur le montant
A1
A3
•
En cas de besoin installer des plaquettes
de compensation (3.3).
Profilés avant
•
Visser les profilés avant sur le châssis
(3.4).
5
A1