IARP A+660 N Gebrauchs- Und Bedienungsanleitungen Seite 16

For proper preservation of the surfaces of the appliance, proceed as follows:
OUTER CABINET: When necessary, gently clean the outer cabinet using a soft cloth dampened with
water and mild detergent solution.
STAINLESS STEEL SURFACES: with warm water and mild detergent with a soft cloth; avoid using
scouring or steel wool pads that may damage the surface.
PLASTIC SURFACES: Wash with water and mild detergent, rinse and dry with a soft cloth; strictly
avoid using alcohol, acetone and solvents that permanently damage the surfaces.
DEFROSTING AND CLEANING THE TANK (A+660 N)
To always get the best performance out of the refrigeration system, a manual defrost is recommended
when the thickness of the frost in the tank is greater than 5 mm; proceed as follows:
1) Remove the product from the tank and store it in a cooler at -18°C.
2) Turn the appliance off at the mains switch (see control panel) and unplug it.
3) On negative models, pour a basin of warm but not boiling water inside of the tank, placing it on a
sheet of cardboard, close the door and wait for about half an hour.
4) Proceed to the washing and drying of the inner tank with a cloth using neutral detergents.
5) Turn the unit back on and wait for the appliance to reach the correct temperature before
loading the product.
Warning! Do not use water jets for cleaning: this can damage the electrical
parts.
Warning! Do not use mechanical appliances or other means to speed up the
defrosting process, other than those recommended by the manufacturer.
CLEANING THE TANK (A+660 P)
For the tank cleaning operations, proceed as follows:
1) Put the product in a special refrigerated container at the same temperature and remove the shelves.
2) Unplug IT.
3) Leave the door open and wait until the internal temperature matches the ambient temperature.
4) Proceed to the washing and drying of the inner tank with a cloth using neutral detergents.
Then turn unit back on and wait for it to reach the correct temperature before refilling it.
Warning! Do not use water jets for cleaning: this can damage the electrical
parts.
Warning! Do not use mechanical appliances or other means to speed up the
defrosting process, other than those recommended by the manufacturer.
-15-